Mailing list for discussions and development of KORUZA, a system for wireless optical networks (in English).

List archive Help


Re: [koruza] KORUZA mounting bracket


Chronological Thread 
  • From: Musti < >
  • To:
  • Subject: Re: [koruza] KORUZA mounting bracket
  • Date: Mon, 01 Sep 2014 14:52:41 +0200

Thanks, but these brackets are all rather flimsy and plastic.
Insufficiently stable for KORUZA.

Kind regards,
Musti

On 1.9.2014 14:36, Valent Turkovic wrote:
> Check out these brackets, maybe some of them will be suitable:
> http://www.eurodk.com/en/products/rf-brackets
>
>
> On Mon, Sep 1, 2014 at 10:57 AM, Musti
> <
> <mailto: >>
> wrote:
>
> Hi folks,
>
> I am reaching out to you for some help.
>
> Thus-far KORUZA has been using mounting brackets, which I had spare from
> some decommissioned equipment and they were custom made, so ti is not
> possible to buy them at the moment.
>
> They look like this:
>
> https://dev.wlan-si.net/raw-attachment/wiki/KORUZA/RealTimeExperiments/koruza-2-1.jpg
>
> For use in the World Wide KORUZA experiment and open source release, I
> am looking for mounts that can be ordered form somewhere.
>
> The requirements are:
> - wall/pole mountable at the same time
> - adjustable with 2 degree or greater accuracy in two axes: pan/tilt
> (KORUZA internal motorized alignment has the movement range of
> approximately 3 degrees)
> - arm between the pieces longer then the mounting piece, so it can be
> attached to the bottom of the unit as on the above photo.
> - sufficiently massive to mount KORUZA
> - can be ordered in reasonable quantities
>
> So far, I have only found one potential candidate:
> http://www.winncom.com/en/products/MT-120018
>
> Please ping me if you have any idea of similar or in general suitable
> mounts.
>
> Kind regards,
> Musti
>
> Settings and unsubscription:
> http://wlan-si.net/lists/info/koruza
>
> Public archive:
> http://wlan-si.net/lists/arc/koruza
>
>



Archive powered by MHonArc 2.6.18.

Top of page