Mailing list for discussions and development of KORUZA, a system for wireless optical networks (in English).

List archive Help


Re: [koruza] KORUZA mounting bracket


Chronological Thread 
  • From: Valent Turkovic < >
  • To:
  • Subject: Re: [koruza] KORUZA mounting bracket
  • Date: Mon, 1 Sep 2014 14:36:25 +0200

Check out these brackets, maybe some of them will be suitable:
http://www.eurodk.com/en/products/rf-brackets


On Mon, Sep 1, 2014 at 10:57 AM, Musti < > wrote:
Hi folks,

I am reaching out to you for some help.

Thus-far KORUZA has been using mounting brackets, which I had spare from
some decommissioned equipment and they were custom made, so ti is not
possible to buy them at the moment.

They look like this:
https://dev.wlan-si.net/raw-attachment/wiki/KORUZA/RealTimeExperiments/koruza-2-1.jpg

For use in the World Wide KORUZA experiment and open source release, I
am looking for mounts that can be ordered form somewhere.

The requirements are:
- wall/pole mountable at the same time
- adjustable with 2 degree or greater accuracy in two axes: pan/tilt
(KORUZA internal motorized alignment has the movement range of
approximately 3 degrees)
- arm between the pieces longer then the mounting piece, so it can be
attached to the bottom of the unit as on the above photo.
- sufficiently massive to mount KORUZA
- can be ordered in reasonable quantities

So far, I have only found one potential candidate:
http://www.winncom.com/en/products/MT-120018

Please ping me if you have any idea of similar or in general suitable
mounts.

Kind regards,
Musti

Settings and unsubscription:
http://wlan-si.net/lists/info/koruza

Public archive:
http://wlan-si.net/lists/arc/koruza




Archive powered by MHonArc 2.6.18.

Top of page